Often asked: How To Build A Soffit Box In Basement?

How do you install plywood soffit?

Fit the first panel of soffit, painted face down, with one narrow end against the inside face of the front gable with its long edges against the back of the fascia and the face of the wall. Nail up through the soffit into the bottom edge of the joists above with 2 inch pin nails, one every 8 inches.

Can you screw into ductwork?

Yes, it can be done, NOyou don’t lose any heat. If you did, then sheet metal screws (in the ductwork already) would be illegal.

Can wood touch ductwork?

Ductwork under normal conditions will not ignite or even char wood. There is no need to insulate the wood from the heat that may be generated.

How can I hide my basement ductwork?

How to Hide That Awful Ductwork!

  1. Create a tray ceiling.
  2. Drop the ceiling in one area to create intimacy.
  3. Create faux rafters.
  4. Use unique soffits when framing out ductwork.
  5. Incorporate ceiling framing with wall framing.
  6. When you can’t beat ’em – embrace them!

Where should heat registers be placed in basement?

The best arrangement for HEATING this basement area would be to have the supply LOW near the floor level (just above the baseboard) and the Return should also be LOW near floor level while as far away as possible from any supply (an opposite wall is best).

You might be interested:  FAQ: How To Build Barbecue Island?

Can drywall touch ductwork?

You can place drywall directly against the duct work with no clearance. If you use 5/8 drywall it has a larger span and you can often avoid framing below the duct. Fram on each side and fasten the drywall from side to side.

How do you hide wires and pipes in a basement?

Read on as we show you ten cheap but interesting ways to cover your exposed pipes.

  1. Go retro.
  2. Add Decorative Wood Pipe Wrapping.
  3. Other Pole and Pipe Coverings.
  4. Use modular blocks.
  5. Build a bookshelf around and/or in front of your pipes.
  6. Use plants to conceal unsightly pipes and other exposed items you want to hide.

How much does it cost to replace support beams in basement?

Given these variables, a basement beam replacement job may cost as little as $7- 8,000 for a simple installation to $20-25,000 for a complex job with long spans and numerous load-bearing walls.

Leave a Reply

Your email address will not be published. Required fields are marked *