Readers ask: How To Build A Faux Fireplace Mantel?

How much does it cost to build a fake fireplace?

The total cost to build the faux fireplace in our family room was around $25. Most of the wood we used was scrap wood (we keep everything!)

Can you build a fake fireplace?

Faux Fireplaces You Can Build



A great option if you don’t want something permanent – if you‘re renting or want the ability to move the fireplace out of the way in warm months. Even the tile not adhered to the floor – you‘ve got to see their solution for this hearth area.

How far should mantle stick out?

A mantel should extend a minimum of 3 inches beyond the firebox opening. If the fireplace has facing around the opening, the mantel can also extend 3 or more inches beyond that. Do not guess when sizing the mantel to a room, or the mantel could wind up being too long or too short.

How do you install a heavy wood mantel?

Make sure those marks are level, centered and extend far enough to cover the mantel’s length.

  1. drill holes at each mark. Drill Sleeve Holes. Drill holes at each mark using a drill and 3/4″ masonry bit.
  2. insert lead sleeves into holes. Insert Sleeves.
  3. drive lag bolts. Drive Lag Bolts.
  4. install the mantle. Install Mantel.
You might be interested:  Often asked: How Much Does It Cost To Build A Sport Court?

Can you put a fireplace in a house that doesn’t have one?

If your home doesn’t have a fireplace, that’s OK: With careful planning, you can add one. As you begin your research, the first thing to know is that fireplaces generally fall into one of three categories: masonry, zero-clearance (also known as pre-fabricated or manufactured), and gas.

Does a fireplace add value to a home?

The National Association of Home Builders notes that an outdoor fireplace can also increase a home’s value! Nearly 80% of real estate agents in the poll conducted by Angie’s List say both indoor and outdoor fireplaces increase a home’s value by anywhere from $1,000 to $5,000.

Can you have a mantel without a fireplace?

Even if you don’t have a fireplace, there’s no reason not to have a mantel as the focal point of your living room. Creating a faux mantel lets you enjoy all the design potential of a cozy hearth without the care and worry a real fireplace can bring.

Do fake fireplaces give off heat?

No, the flame on an electric fireplace is not real.



The heat is provided from the heating element that is separate to the flame. The flame is produced from a standard light bulb, usually an LED, from which the light is refracted in a pattern that resembles a flame.

How do you make a homemade mantel?

Instructions

  1. Cut the 10″ boards to the appropriate length.
  2. Use wood glue and finishing nails to attach the two boards together.
  3. Cut this board to the length of your mantel.
  4. Attach with wood glue and finishing nails.
  5. Cut a board to size to fill the gap on the bottom of the mantel.
You might be interested:  Around How Much Does It Cost To Build A House?

Can you put a fireplace on a flat wall?

Flat wall fireplaces, often referred to as slimline fireplaces, are available in both traditional and modern styles, with a varied choice of materials, including marble mantels and wooden surrounds, with cast iron fireplace inserts and fascias to perfectly complement the quality electric fires.

How do you attach a floating mantel to a brick fireplace?

How to Install a Mantel

  1. Remove the old mantel.
  2. Add support by drilling holes for lag shields, then install lag bolts into the brick.
  3. Measure carefully and drill corresponding holes for the wood mantel.
  4. Push the wooden mantel carefully into place using wood glue for extra support.

How do you remove a floating mantel?

Pound the bottom of the mantel shelf with a rubber mallet to separate it from the wall if it doesn’t release when you pry the base of the mantel away from the wall. Tap it gently, but with enough force to pull the nails from the wall. Once it’s loosened, pull out on the shelf to remove it.

Leave a Reply

Your email address will not be published. Required fields are marked *